JUAL ATTEN AT7340 ANALOG OSCILLOSCOPE ( 40MHz )

ATTEN AT7340 ANALOG OSCILLOSCOPE ( 40MHz )
Harga :: Rp 6.400.000

Features :

• Dual channel - channel bandwidth: 40 MHz
  High Sensitivity 1Mv/DIV
  5mV/div Sensitivity on Both Channels
  CH1 & CH2 Independent Channels
  CH1 Signal Output
  Two waveforms in different frequency can be observed via alternative trigger function
  High-speed sweep
  Algebraic Addition and Subtraction
  X-Y Operation
  0.2μs/div to 0.5s/div Time Base(Uncal upto 20ns)
  Z Modulation TTL Level
  8 x 10 cm Display Internal Graticule
  TV signal synchronous function, TV Triggering Frame (V) & Line (H)
  Line Trigger ALT Triggering

AT7340 Model TECHNICAL SPECIFICATIONS
VERTICAL AXIS
Sensitivity	5mV~5V/DIV, 10 steps in 1-2-5 sequence (X5 MAG: 1mV/DIV)
Sensitivity accuracy	≤3% (×5MAG: ≤5%)
Vernier vertical sensitivity	continuously variable to 1/2.5 or less of panel-indicated value
Frequency bandwidth	DC-20MHz (×5MAG:DC-7MHz) DC-40MHz (×5MAG:DC-15MHz)
AC coupling	Low limit frequency 10Hz. (With reference to 100KHz,8DIV.Frequency response with-3dB)
Rise time	Approx.17.5Ns (×5MAG:Approx.50Ns) / 9.5nS (X5MAG: Approx.25nS)
Input impedance	Approx. 1M ohm//Approx. 25pF
Square wave characteristics	Overshoot: ≤5%(At 10Mv/DIV range) other distortions and other ranges: 5% added to the above value DC balance shift: 5mV~5V/DIV; ±0.5 DIV, 1mV~2mV/DIV±2.0DIV Linearity: ? ±0.1DIV of amplitude change when waveform of 2 DIV at graticule center is moved vertically.
Vertical modes	CH1 single channel. CH2 single channel
DUAL	CH1 and CH2 are displayed ALT or CHOP selectable at any sweep rate.
ADD	CH1+CH2 algebraic addition
Chopping repetition frequency	Approx.250KHz
Input coupling	AC, GND , DC
Maximum input voltage	300V peak (AC: frequency 1KHz or lower) When set probe switch at 1:1, the maximum effective readout is 40Vp p(14Vrms at sine wave); or set probe switch at 10:1, the maximum effective readout is 400Vpp(140Vrms at sine wave)
Common mode rejection ratio	50:1 or better at 50KHz sinusoidal wave.(when sensitivities of CH1 and CH2 are set equally)
Isolation between channels (at 5Mv/DIV range)	> 1000:1 at 50 MHz; > 30:1 at 20MHz; > 30:1 at 40MHz
CH1 signal output	At least 20Mv/DIV into a 50 ohm termination, Bandwidth is 50Hz to at least 5MHz.
CH2 INV BAL	Balanced point variation: ≤1DIV(Reference at center graticule)
HORIZONTAL AXIS
Sweep time	0.2μSec-0.5Sec/DIV,20Steps in 1-2-5sequence
Sweep time accuracy	±3%
Vernier sweep time control	≤1/2.5 of panel-indicated value
Sweep magnification	10 times
×10MAG sweep time accuracy	±5%(20nsec-50nsec are uncalibrated)
Linearity	±3%,×10MAG: ±5%(20ns and 50ns are uncalibrated)
Position shift caused by×10MAG	Within 2 DIV, at CRT screen center
TRIGGERING
Triggering source	CH1, CH2, LINE, EXT
Coupling	AC:20Hz to full bandwidth
Slope	+/-
Sensitivity	20Hz-2MHz: 1.0 DIV, TRIG-ALT: 2DIV,EXT:200Mv; 2MHz-20MHz: 1.5DIV; 20MHz or higher: 2.0DIV TRIG-ALT: 3DIV,EXT:800mv
TV	Sync pulse more than 1 DIV (EXT:1V)
Triggering modes	AUTO; NORM; TV-V; TV-H. (Both TV-V and TV-H synchronize only when the synchronizing signal is negative)
Input impedance	Approx:1M ohm//approx.25pF

Free Ongkir wilayah Jakarta & Tangerang dan sekitarnya

Melayani pemesanan untuk dalam dan luar kota

Untuk informasi dan pemesanan hubungi :

KARYA NUSATAMA

Contact Person: Yoga Sutama

Tlp : 02149722589

Esia Mobile :: 02193096961

Mobile : 085880111657

Email : yogakarya1@yahoo.co.id

Gmail : yogakarya3@gmail.com

YM : yogakarya2

Website : http://www.karyanusatama.com

Link : http://karyanusatamagroup.indonetwork.co.id

Related product you might see: